![]() This is the factory default operation of the amplifier. The amplifier will remember the last mode it was in after power off and revert to it the next time it is powered on. When in manual mode the Store switch (12) lights red and the selected channel light (3 or 5) will start to flash. To change between these two modes, you must hold the Tap switch (10) down for at least two seconds. The amplifier operates in two modes - Preset and Manual. ![]() If you have moved from the Crunch Channel to an OD channel and you press the Clean/Crunch switch (3), the amplifier will revert back to the Crunch channel - rather than starting again in the Clean channel. When moving from an OD channel to a Clean/Crunch channel, the unit remembers the last channel you were in before leaving. Pressing the OD switch (5) selects between the OD1 (Green Light) and OD2 (Red Light) channels. Pressing the Clean/Crunch switch (3) selects between the Clean (Green Light) and Crunch (Red Light) channels. The amplifier has 4 channels - Clean, Crunch, OD1 & OD2. MG15FX & MG30FX Overview Channel Selection Please ensure the amplifier is switched off and unplugged from the mains electricity supply before being moved. Your Marshall dealer will help you in this respect. If you have any doubt, please get advice from a qualified technician. Before connecting to the mains electricity supply, always ensure that your amplifier is compatible with your electricity supply. Note: The specific mains input voltage rating that your amplifier has been built for is shown on the back panel. A channel switch will light up when your amplifier is turned on and none will be lit when the amplifier is switched off. The power switch turns your amplifier on and off. Connection of headphones will automatically mute the internal speaker. ¼" Jack socket for the connection of the optional footcontroller (PEDL-90008).įor use when silent practice is the order of the day. Adjust the volume of your player to match that of your guitar and you've got the perfect 'playalong' practice system. Jam to your favourite MP3, CD or tape track by connecting the line out or headphone output of your player here. When in manual mode the Store button lights red.Ĭontrols the master volume of the amplifier. Stores the current amp settings into the current channel or into the optional footcontroller. Selects and adjusts one of four effects - Chorus, Phaser, Flanger & Delay. When using the optional footcontroller, holding both the Tap switch and the Store switch will activate the tuner. Holding down the Tap switch for longer than 2 seconds switches the amp between manual and preset mode (pg 2). The LED flashes at the selected delay time. Matches the delay FX time to the time between two pushes. This control lets you add a lush reverb to the selected channel, from a subtle hint to cavernous and all points in-between.Ĭontrols the volume of the selected channel. Increasing the Treble will make your sounds brighter and more cutting, turning it down will decrease your tone's edge and make it sound softer as a result. Selects between OD1 (green) and OD2 (red) channels.Īdjusting the middle frequencies will vary the amount of body in your sound. Turning up the Bass control will add warmth and lowend depth to your sound. Selects between Clean (green) and Crunch (red) channels. one that's screened/shielded) to help prevent noise, interference and unwanted feedback.Ĭontrols the amount of signal entering the pre-amp and the amount of distortion created in the selected channel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |